DENSO Australia Product Range – Mastic, Tape, Overwrap Tape & Primer

Denso Australia Black Overwrap Tape:

• Based upon a stabilised and plasticised PVC film coated with a pressure sensitive natural rubber based adhesive
• Exhibits a wide ranging resistance to acids, alkalis and salts
• Will afford increased mechanical and dielectric strength when applied over Denso Australia tape
• Can be used for mechanical, sealing and water proofing metal above or below ground in pipelines
• Can also be used in duct sealing, duct jointing, electricians tapes and temporary leak repair damaged pipes/drums
• Produced by Denso Australia

 

Denso Australia Mastic 3KG HT (High Temperature):

• Based upon reinforced petrolatum compound blended with thermal extenders, inert fillers, corrosion inhibitors and wide spectrum biocide
• Formulated for stability and plasticity over a wide temperature range
• Will profile crevices and sharp angular profile changes enabling Denso Australia tape to be applied without bridging or voiding
• Can be used for profiling around pipe joints, flanges, fittings, nuts, bolts and other irregular shapes in pipelines to provide contours for subsequent tape wrapping
• Can also be used for sealing cable and pipe entry ducts, temporary plugging of spare ducts and filling electricial gland and junction boxes
• Produced by Denso Australia

 

Denso Australia Tape ST (Standard Temperature) 150mm x 10m:

• Based upon a Non Woven polyester fabric which has been fully impregnated and saturated with a petrolatum compound, blended with inert fillers, corrosion inhibitors and wide spectrum biocide
• Exhibits wide ranging resistance to acids, alkalis and bacteria
• Will not polymersise or oxidise
• Its non-hardening properties allow the product to accommodate both substrate vibration and movement
• Will adhere and remain attached to clean, wet or dry metal surfaces
• Can be used for above ground, below ground and submerged pipes and fittings in pipelines
• Can also be used for tie rods, starter bars, bond breakers, slipform release tapes and roof sheet isolation tapes
• Manufactured in accordance with AWWA Standard C217-04
• Produced by Denso Australia

 

Denso Australia 2.5KG Multi Purpose Primer:

• Used to prepare surfaces as part of the Denso Australia petrolatum system
• Formulated for stability and plasticity over a wide temperature range
• Will profile minor surface imperfections and enable uniform adhesion of Denso Australia Mastic and Denso Australia Tape to the cleaned substrate
• Highly resistant to mineral acids, alkalis and salts
• Will adhere and remain attached to clean, wet or dry metal surfaces
• Can be used for corrosion protection, water-proofing, sealing, joints, fittings, cables and tensioning members in pipelines when used as part of the Denso Australia system
• Can be used for rust prevention of screw threads, valve spindles, turnbuckles, wire rope etc. and temporary protection on exposed metals
• Produced by Denso Australia

All products are covered by the full manufacturer’s warranty of 2 years. Should you have an item that is faulty we are happy to replace with a new one. Please contact us with details and/or photos of the fault as well as your contact details so we can discuss the issue and organise a replacement at our cost, or if you prefer we can provide a full refund. In some cases, we may request the item be returned to us depending on the issue.